I finally finished my carb rebuild! cleaned up and painted with "Eastwood Carb Renew II" chemical and gas proof paint specifically made for carbs. I think it looks spiffy.
Here's the Air filter and carb together as before and after shots... I'd say it's quite an improvement...
And after I got my new Air compressor working, I tested out my new Dual Action sander on the driver's front quarter panel.
I decided the inside needed to soak a little more before the final sand and priming before I learn to weld in the patch panels! I have thought about just using fiberglass to patch up around the eyebrows and the rear of the panel, but several people have told me that welding in patch panels is the best way to go... so I guess I'll try to do it the right way even though it's going to cost A LOT more to buy&weld in new sheetmetal.
Here's the Air filter and carb together as before and after shots... I'd say it's quite an improvement...
And after I got my new Air compressor working, I tested out my new Dual Action sander on the driver's front quarter panel.
I decided the inside needed to soak a little more before the final sand and priming before I learn to weld in the patch panels! I have thought about just using fiberglass to patch up around the eyebrows and the rear of the panel, but several people have told me that welding in patch panels is the best way to go... so I guess I'll try to do it the right way even though it's going to cost A LOT more to buy&weld in new sheetmetal.
No comments:
Post a Comment